主頁 > ProGear BL806 Robot Servo, Robot Servo, Servo, 機械人, 機械人製作 > Robot Servo ProGear BL806 Report – chapter 1

Robot Servo ProGear BL806 Report – chapter 1

this time I have writing in English , because I have to share some information with the Robot friends at the foreign country , The Robot Servo – ProGear BL806 is a high quality servo for making robot.

For making robot , we always use GWS , TowerPro , Futaba , or any high torque digital servo … but the robot still didn’t works good, I think that the problem is come form the Servo , it is because when the factory design a servo, it is for the RC model car or plane , it is not for the Robot use , this means the servo are low grade , so the servo are easy get damage , followings you can see what is the different between RC servo & Robot Servo.

SANY0030a_resize 1. Size , the ProGear BL806 size like the standard servo , it is 42.8 x 41 x 21.2mm , the size is good for make a robot around 350mm tall . One pc of ProGear comes with a 3.9mm thick circle horn , the horn include 4pcs screw nut inside the horn , & the package include 4pcs 2m x 4.5 screw , 6pcs 2 x 5 KA & 1pc 2.5m x 6 for fix the horn.
SANY0025_resize
SANY0026_resize2. Axle , the ProGear BL806 have double side of axle , one side of the axle can be remove or use for you choose .
SANY0034_resize
3. Horns , if you don’t want to use the horn come with the BL806 , you can choose any other brand of the horn , because the VR teeth is same of the Futaba , it can use many brand of third party horns you choose.
SANY0035_resize
SANY0036_resize
4. fix with the 6pcs 2 x 5 KA screw , the BL806 comes with 6pcs 2 x  5 KA screw , it is for fix the servo , at the top face it have seven hole for fix the servo , at the back , it have four hole for fix servo.
SANY0021_resize
5. the input & output , The ProGear BL806 have got 2 connector at both side , it is the input or output for both connector , when you plug at side left connector , the right side connector will be the output , this means you can connect two servo with one PWM signal , when you want to control with different signal , you can use two pin for the power & the signal pin can connect to you servo controller , then you don’t need to connect all servo with many of wire to the servo controller . the weight of your robot will get light.

SANY0037_resize


廣告
  1. 仍無迴響。
  1. No trackbacks yet.

發表迴響

在下方填入你的資料或按右方圖示以社群網站登入:

WordPress.com Logo

您的留言將使用 WordPress.com 帳號。 登出 / 變更 )

Twitter picture

您的留言將使用 Twitter 帳號。 登出 / 變更 )

Facebook照片

您的留言將使用 Facebook 帳號。 登出 / 變更 )

Google+ photo

您的留言將使用 Google+ 帳號。 登出 / 變更 )

連結到 %s

%d 位部落客按了讚: